Wiring Diagram; For Models With On/Off Worm Gear Motor; For Models With A Permanently Rotating Worm Gear Motor - Austroflamm Ruby User Instructions

english

8 Wiring Diagram

Note: Repairs to your pellet stove must only be carried out by approved Austroflamm technicians.
8.1 For models with ON/OFF worm
gear motor
1. Magnetic switch (hopper lid)
RPM / HAL-IC
2.
Earthing – ID fan
3. Earthing – DC control side
4. Room temperature sensor
5. Firebox temperature sensor
Differential pressure measurement
6.
P1, P2
7.
Ceramic ignition
8. ID fan
9.
Air distribution module (optional)
10. ON / OFF – worm gear motor
11. Blank capacitor
12. Safety temperature limiter
13. Jumper "I02"
(OPT) External thermostat
8.2 For models with a permanently
rotating worm gear motor
1.
Phase converter
RPM / HAL-IC
2.
Earthing – ID fan
3. Earthing – DC control side
4. Room temperature sensor
5. Firebox temperature sensor
Differential pressure measurement
6.
P1, P2
7. Ceramic ignition
8.
ID fan
9. Air distribution module (optional)
Current signal - permanently
10.
rotating worm gear motor
11.
Safety temperature limiter
12. Hopper lid / Safety switch
Grate motor, current release for
13.
worm gear motor
14. Grate motor
(OPT)
External thermostat
25