GLP JDC Line 500 User Manual page 27

German Light Products®
DMX Mode 4: White + RGB Strobes + W
Pixel
47 DMX Channels
White segments overall control gives
overall output control of the
individually controllable White
segments at the end of this DMX mode
(see below). It offers the standard
strobe channels for intensity and strobe
effects.
RGB strobe with FX provides an RGB
color strobe that runs on the RGB
segments only. It has an effects engine
with 50 patterns. Crossfading sets the
duration of changes between the
steps in each pattern and transition
sets the duration of changes from one
pattern to the next.
Pattern chain length sets up a chain of
fixtures for the pattern to run across in a
chase – it defines the total number of
fixtures in the chain. Position in chain
lets you set which position in the chain
the fixture will occupy: first, second or
third etc. fixture in the chain.
Strobe phase lets you shift the timing of
the RGB strobe by 1 – 359° relative to
the White strobe. A 180° shift will result
in a flip-flop between flashes on the
two strobes.
Background color sets a background
color on the RGB segments. As
standard, the main color output always
has higher priority than the
background color. You can define
how background color and main color
are mixed using Background color on
the Control/Settings channel.
White + RGB Strobes + W Pixel
White segments overall control
1 Intensity coarse
2 Intensity fine
Duration
3
4 Flash rate (Shutter)
5 Intensity effects (Strobe mode)
6 Control / Settings
RGB strobe with FX
7 Intensity coarse
8 Intensity fine
9 Duration
10 Flash rate (Shutter)
11 Intensity effects (Strobe mode)
12 CTC
13 Red
14 Green
15 Blue
16 Pattern select
17 Pattern step / speed
18 Pattern step crossfade
19 Pattern transition
20 Pattern chain length
21 Position in chain
22 Strobe phase
Background color
23 Intensity background
24 Red background
25 Green background
26 Blue background
27 White background
White segments individual control
28 White segment 01
... ...
47 White segment 20
White segments individual control adjusts
the output of the individual White
segments. The overall output of these
segments is determined by the White
segments overall control (see above).
Control / Settings lets you configure the
fixture remotely via DMX.
Rev. 20210318-01
Mode 4
27