GLP JDC Line 500 User Manual page 22

www.glp.de
Device Power Cycles
Show DMX Input
Show Signal Quality
Show Temperature
Show Fan Monitor
Manual Control
Reboot (confirm 3 sec.)
Intensity coarse
(RGBW)
Intensity fine (RGBW)
Duration (RGBW)
Rate (Shutter)
(RGBW)
Intensity Effects
[Strobe Mode]
(RGBW)
CTC
Manual DMX
R
G
B
W
Capture DMX values (confirm 3 sec.)
Reset Manual values (confirm 3 sec.)
Service
Test All Confirm
Test White Confirm
Test RGB Confirm
Reset Counters
Advanced
(Press and
hold Enter for
Save Settings
3 sec. to
confirm)
Load factory backup (confirm 5 sec.)
Default settings are written in BOLD type.
22
000 - 255
000 - 255
000 - 255
000 - 255
000 - 255
000 - 255
000 - 255
000 - 255
000 - 255
000 - 255
Device Hours (confirm 3
sec.)
Device Power Cycles
(confirm 3 sec.)
Max Temperatures
(confirm 3 sec.)
Preset 1 (confirm 3 sec.)
Preset 2 (confirm 3 sec.)
Preset 3 (confirm 3 sec.)
JDC Line 500 User Manual
Shows resettable and non-
resettable power cycle counters
Shows DMX values received for all
functions
Shows signal quality (framerate,
noise, etc.)
Shows temperatures in °C & °F
Shows fan rpm and Voltage
Reboots fixture
Manual fixture control
Takes a snapshot of DMX values
currently being received and uses
them as manual DMX values
Resets all manual DMX values to
default
Runs continuous test sequence:
pan & tilt first, then all FX with head
straight up. Stop test by pressing
"Back" button.
Runs continuous test sequence on
White LEDs. Stop test by pressing
"Back" button.
Runs continuous test sequence on
RGB LEDs. Stop test by pressing
"Back" button.
Returns resettable counter to zero
Saves all custom settings including
offsets as a preset
Loads factory default settings,
resets custom offsets, deletes
custom presets, sets resettable
counters to zero, sets DMX address
to 1, sets DMX mode to default
(Mode 2: WStrobe + RGBStrobe)