Table of Contents
Advertisement
German Light Products®
When you apply power to the fixture it takes a few seconds to boot. After it has
booted, the panel displays the default screen.
DMX control is disabled when the control menus are active.
A number of options for customizing the onboard display are available on the DMX
Control / Settings channel and in the Display control menu in the control panel.
Quick menu
A quick menu is provided to save time. To open the quick menu, activate the default
screen by pressing the MENU button and then press the ENTER button
The quick menu gives you the following options:
● Toggle the display orientation between auto, normal and inverted.
● Reboot the fixture.
● Load any of the three custom setting presets that have been saved previously or
load the factory default settings.
● Reinitialize the fixture by returning all settings to factory defaults, deleting all custom
presets, returning all resettable counters to zero, setting the fixture's DMX address to
1 and setting the DMX Mode to the factory default (Mode 2: W Strobe + RGB
Strobe).
Quick access options
When the fixture is connected to mains power and has booted normally, the following
functions can be accessed quickly by pressing key combinations.
● Holding UP and DOWN pressed together for less than one second toggles the
display orientation.
● Pressing UP or DOWN three times calls up a readout of the main fixture information
and the fixture's settings.
Battery Eco mode
When the fixture is not connected to mains power and is running on its internal battery,
holding MENU and ENTER pressed in together for 10 seconds activates Battery Eco
Mode. This disables battery power to protect the battery from being run flat if the
fixture is accidentally switched on during transportation.
Put the fixture into Battery Eco Mode before transportation or long-term storage.
To take the fixture out of Battery Eco Mode, simply connect it to power.
Rev. 20210318-02
»
.
17
Advertisement
Table of Contents
