Table of Contents
Advertisement
TOOLS REQUIRED
Power drill
Spanner or adjustable crescent
INSTALLATION
IMPORTANT:
Galvin Specialised products must be installed in accordance with these installation instructions
and in accordance with AS/NZS 3500, the PCA and your local regulatory requirements. Water and/or electrical
supply conditions must also comply to the applicable national and/or tate standards. Failing to comply with these
provisions shall void the product warranty and may affect the performance of the product.
1. Fit push button
Fit the push button into the bench.
Ensure the sealing o-ring is placed underneath the
push button and the anti-rotation pin locates properly.
Secure underneath with the supplied cup washer and
back nut.
3. Fit inlet and outlet connections
Fit outlet connection.
Connect water supply to isolation valve inlet
Version 1, 16 March 2017, 2 of 4
2. Assemble valve body
Assemble the valve body to the push
button.
Ensure to apply thread tape for sealing.
Take care not to over-tighten.
4. Testing
Turn mains supply on and push button to
ensure that there is flow from outlet.
Inspect the tap and check for any leaks.
Adjust flow with isolation valve, so
required flow is achieved
Advertisement
Table of Contents
Need help?
Do you have a question about the Safe-Cell 50145 and is the answer not in the manual?