Ducted dual flush pan assembly for mains with controller (12 pages)
Summary of Contents for Galvin Specialised Ezy-Wash TF83HJS
Page 1
TF83HJP SPECIFICATIONS Galvin Specialised recommends the installation of strainers and pressure reducing valves prior to installing the pre-rinse unit to ensure clean consistent water supply. Debris or poor water quality could cause the trigger to seize or fail to seal.
Version 1, 11 July 2017, Page 2 of 5 PRE-INSTALLATION Body: If the mounting holes do not already exist, mark out and drill the holes in the bench, as shown. This model is a dual inlet unit requiring a hole diameters of 23mm - 26mm, 205mm apart.
Version 1, 11 July 2017, Page 3 of 5 INSTALLATION INSTALLATION COMPLIANCE: Galvin Specialised products must be installed in accordance with these installation instructions and in accordance with AS/NZS 3500, the PCA and your local regulatory requirements. Water and/or electrical supply conditions must also comply to the applicable national and/or state standards.
The isolation or main taps must be turned OFF whilst the unit is not in use so that the unit is not under mains pressure when unsupervised. Flood damage may occur if a failure occurs whilst the unit is under mains pressure. (warranty is void in this instance). Galvin Specialised recommends the handpiece be removed periodically for servicing by a qualified plumber.
Version 1, 11 July 2017, Page 5 of 5 WARRANTY The warranty set forth herein is given expressly and is the only warranty given by the Galvin Engineering Pty Ltd. With respect to the product, Galvin Engineering Pty Ltd makes no other warranties, express or implied. Galvin Engineering Pty.