Galvin Specialised CliniLever Lead Safe TM-SHWX Product Installation Manualline

Galvin Specialised CliniLever Lead Safe TM-SHWX Product Installation Manualline

Stainless steel shower mixer

Advertisement

Quick Links

®
CliniLever
Lead Safe
PRODUCT CODES:
 TM-SHWX

SPECIFICATIONS

Lead Safe
stainless steel construction
Easy temperature blending and operation to ensure comfort and safety for the user
Low maintenance
Clean hygienic design
IMPORTANT: All CliniLever
premises in good working order.
As 'lead free' is not currently defined by low in Australia and New Zealand, we have based our definition of Lead Safe™ on the requirements of s1417 of the USA's Safe Drinking Water Act (SDWA)
and the relevant US standards NSF61 / NSF372. The SDWA defines 'lead free' as "not more than a weighted average of 0.25% lead when used with respect to the wetted surface of pipes, pipe fittings,
plumbing fittings and fixtures".

TECHNICAL DATA

Inlet
Outlet
Headwork
Working Pressure Range (kPa)
Working Temperature Range (°C)
Nominal Flow Rate (LPM)
Construction
Finish
NOTE: Galvin Engineering continually strive to improve their products. Specifications may change without notice.
Stainless Steel Shower Mixer
®
Shower Mixers are tested in accordance with AS/NZS 3718 and leave our
th
Version 1,14
April 2020, 1 of 4
½" BSP - Female
½" BSP - Female
Ceramic Disc
Min
50
Max
500
Min
5
Max
80
N/A
Stainless Steel
Stainless Steel

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CliniLever Lead Safe TM-SHWX and is the answer not in the manual?

Questions and answers

Summary of Contents for Galvin Specialised CliniLever Lead Safe TM-SHWX

  • Page 1 Version 1,14 April 2020, 1 of 4 ™ ® CliniLever Lead Safe Stainless Steel Shower Mixer PRODUCT CODES:  TM-SHWX SPECIFICATIONS  ™ Lead Safe stainless steel construction  Easy temperature blending and operation to ensure comfort and safety for the user ...
  • Page 2 Version 1,14 April 2020, 2 of 4 DIMENSIONS Version 3, 7 May 2020, Page 2 of 4 Rough-in Dimensions INSTALLATION INSTALLATION COMPLIANCE: Galvin Engineering products must be installed in accordance with these installation instructions and in accordance with AS/NZS 3500, the PCA and your local regulatory requirements. Water and/or electrical supply conditions must also comply to the applicable national and/or state standards.
  • Page 3 Version 1, 7 May 2020, 3 of 4 Mixed water outlet Mounting point Version 1, 7 May 2020, 3 of 4 Hot water inlet Cold water inlet 3. Secure Mixer Body 4. Fit Water Connections  To allow proper fitment of the wall flange, ...
  • Page 4 Version 1, 7 May 2020, 4 of 4 Version 1, 7 May 2020, 4 of 4 TROUBLESHOOTING PROBLEM CAUSE RECTIFICATION Remove and inspect the headworks, Headworks are worn or Wall shower is dripping water remove debris and/or replace o-rings or damaged parts if damaged Apply more thread tape or sealant to...

Table of Contents