Ducted dual flush pan assembly for mains with controller (12 pages)
Summary of Contents for Galvin Specialised Ezy-Drink Lead Safe 316 SS TD15XEM
Page 1
Output 6.75V DC 0.5A Input Voltage 6V DC Cable length 90mm Solenoid ½” BSP - Female Inlet Connection ½” BSP - Male Outlet Finish Stainless Steel NOTE: Galvin Specialised continually strive to improve their products. Specifications may change without notice.
Page 2
INSTALLATION IMPORTANT: Galvin Specialised products must be installed in accordance with these installation instructions and in accordance with AS/NZS 3500, the PCA and your local regulatory requirements. Water and/or electrical supply conditions must also comply to the applicable national and/or state standards. Failing to comply with these provisions shall void the product warranty and may affect the performance of the product.
Page 3
Version 1, 7 February 2020, Page 3 of 4 3. Fit Piezo Button 4. Install Piezo Button, Solenoid and Transformer Install piezo button through the trough Connect Piezo button, the solenoid & the power supply ensuring that the coloured washer is in to the eletronic control unit.
Page 4
Version 1, 7 February 2020, Page 4 of 4 SET WATER FLOW DURATION Controller Button Switch the power to the controller off. Once again, push the piezo button 5 times. The red light on the controller should now be lit. After 5 seconds switch the power on.