Connecting To The Mpi Control Panel; Installing The Sma Isolators On The Mpi Cabinet - Honeywell MAXPRO MPIP2000U Series Installation And Setup Manual

Honeywell MAXPRO Intrusion MPIP2000U/3000U Series
4.2.5

Connecting to the MPI Control Panel

To connect the 4G/LTE module to the control panel, proceed as follows:
1. Connect the module's PWR/IO and USB connectors (F and G) to the
MPI Control Panel using the included cables.

Caution!
Insert the plugs into the PWR/IO connectors very gently; do
not apply any pressure if the plugs don't enter immediately. If
you do apply pressure, you will bend the pins in the connectors.
Make sure to align the chamfered corners of plug and
connector correctly:
2. Clip the ferrite bead over the USB cable (F). Position it as close as possible
to the USB port on the control panel.
4.2.6

Installing the SMA Isolators on the MPI Cabinet

To install the SMA isolators, proceed as follows:
1. Remove the antenna knockouts from the top of the MPI cabinet (B on
page 27).
2. Place the flat washer (J) on top of the cabinet knockouts, then insert the
SMA isolator (I) through the knockouts.
800-23044 Rev. A draft_11
Installation and Setup Guide
4G/LTE CELL RADIO
Slide right to open
G
F
Network
Connected
800-24408 Rev C
53