Honeywell MAXPRO MPIP2000U Series Installation And Setup Manual page 61

Honeywell MAXPRO Intrusion MPIP2000U/3000U Series
2. Separate the back plate from the lid: press the two tabs at the bottom of
the keypad, and remove the lid.
3. Place the back plate on the wall at the desired location, and mark the
position of the mounting holes. There are 4 mounting holes available (B).
Use the one at the top, and at the bottom you can use the one in the
middle or the two at the edges, depending on your needs.
A
B
A
E
A
F
B
A Opening for wiring (x 3)
B Mounting screw holes (x 4)

Note
The 2 mounting holes in the middle (top and bottom)
correspond with the mounting holes in a standard US wall box.
4. Remove the back plate from the wall, and then drill the holes as required.
5. Screw the back plate to the wall using the large screws, while running
the wiring through the available openings.
6. Screw the tamper screw (F) into the wall. This screw provides off-wall
tamper protection.
800-23044 Rev. A draft_11
Installation and Setup Guide
E IB2 bus connector
F Tamper screw (x 1). Required
for off-wall tamper protection.
61