Configuration: Network Management - HP AH164A - StorageWorks 1/8 G2 Tape Autoloader Ultrium 448 Addendum

Configuration: Network Management
Use the Configuration: Network Management page to enable and configure SNMP (Simple
Network Management Protocol), which allows applications such as HP Systems Insight Manager
(http://www.hp.com/products/SystemInsightManager) to manage the device. The device supports
both SNMP configuration and SNMP traps. SNMP can only be configured with the RMI; it cannot
be configured with the OCP.
Figure 3 Configuration: Network Management page
You may change the:
• SNMP Enabled — When checked, the device can be managed by computers listed in the SNMP
Target IP Addresses field.
• SNMP Target IP Addresses — the IP addresses for up to three computers for IPv4 and three
computers for IPv6 running SNMP management software. IP addresses will not be cleared if
SNMP is disabled, but those targets will no longer be able to manage the Autoloader and will
not receive traps from the Autoloader. You can select the SNMP version for each target address.
• Community Name — a string used to match the SNMP management station and device. It must
be set to the same name on both the management station and the Autoloader. The default
community name is public.
• SNMP Trap Notification Filter — the types of events for which the device should send SNMP traps.
For instructions on configuring HP Systems Insight Manager for the Tape Autoloader, see the User and
service guide on the documentation CD.
6