Quick Guide For Installation; Introduction; Functional Overview (Fig. 2); Mounting And Installation Procedure (Sequential) - Danfoss Link HC Installation Manual

Installation Guide Danfoss Link™ HC

1. Quick guide for Installation

1
Mount the Danfoss Link™ HC, connect
all actuators (TWA) and power-up the
unit
3
Create rooms, add outputs and Room
Thermostats - choose
output type in actuator
settings
5
Add any other devices to the system

2. Introduction

Danfoss Link™ is a wireless control system for a variety of heating systems.
The Danfoss Link™ HC is a part of this system allowing wireless control of manifolds for water based
floor heating/cooling.

3. Functional Overview (fig. 2)

Output LEDs.
Boiler relay.
Pump relay.
Actuator connections.
Install/Link Test.
External antenna connection.
Front cover release.
Not in use (Input 1).
Away Function (Input 2) (external ON/OFF switch).
Input for heating/cooling (Input 3) (external ON/OFF switch).
Output cable fixing.

4. Mounting and Installation Procedure (Sequential)

The wireless systems transmission range is sufficient for most applications; however, wireless signals
are weakened on the way from the Danfoss Link™ to the Room Thermostats and each building has
different obstacles.
Checklist for optimal installation and best wireless signal strength (fig. 1):
• No metal objects between the Danfoss Link™ HC and the Room Thermostats.
• Wireless signal through walls on shortest possible diagonal distance.
• Optimise the wireless signal by installing a RU Repeater Unit.
Note! Danfoss recommends that an installation plan is made before beginning the actual installation (fig. 1).
6 2019.09
2
Add Danfoss Link™ HC to the
Danfoss Link™ CC as a
service device
4
Check the configuration in
Danfoss Link™ HC
setting menu
6
Perform a network test
VIFZL55X Danfoss Heating Solutions