Table of Contents
Advertisement
10.1 Connecting to the Skid Steer Hitch
1. Check with your local Schulte dealer or the
factory to ensure that you have the correct size
hydraulic motor and the proper mount frame for
your make and model of skid steer.
2. Bolt the mount assembly (B750-307) and the
lower mount arms (B750-206) to the main
housing using four 5/8 x 4 bolts, and four 5/8
locking flange nuts. Bolt the assembly to the
gearbox using two 3/8 x 1 bolts, two 3/8 lock
washers and two 3/8 flat washers.
3. Mount the hydraulic motor on the mount plate
and install the 16 tooth sprockets on the motor
and the gearbox. The set screw on the splined
sprocket must line up with the groove on the
gear box input shaft. Bolt the mount plate to the
mount assembly using four 1/2 x 1-1/2 bolts,
four 2 flat washers and four 2 locking flange
nuts.
4. Align the sprockets and install the double chain.
5. Bolt the top link arm (B750-308) to the main
housing with two 5/8 x 4 bolts and two 5/8
locking flange nuts.
6. Bolt the appropriate skid steer quick mount
frame to the lower mount arms using two 7/8 x
2-1/2 bolts and two 7/8 locknuts. Bolt the quick
mount frame to the top link arm with two 5/8 x 4
bolts and two 5/8 locking flange nuts.
7. Follow the instructions with your skid steer
loader to quick attach the snow blower to the
skid steer loader.
10.2 Connecting Snow Blower Hydraulic Lines to the Tractor
With the tractor shut down and secured in position, relieve hydraulic pressure from the tractor by moving the
control levers back and forth several times or placing the levers in the float position. Keep implement hydraulic
lines, hoses, quick couplers, and swivels free of contamination. Never leave a disconnected hose end open
and cap the tractor hydraulic outlet ports when not in use. If the tractor ports, Snow Blower ports and hydraulic
hose ends become contaminated, wipe clean with a rag before connecting.
SBX-75/87 04/19
© 2019 Alamo Group Inc.
OPERATION
Operation Section 4-17
Advertisement
Table of Contents
