Table of Contents
Advertisement
Only operate the snow blower in conditions were you have clear visibility in daylight or with
adequate artificial lighting. Never snow blow in darkness or in conditions where you cannot
clearly see at least 100 yards in front and to the sides of the Tractor and Snow Blower.
Make sure that you can clearly see and identify passersby, steep slopes, ditches, drop-offs,
overhead obstructions, power lines, debris and foreign objects. If you are unable to clearly
see these types of items, discontinue snow blowing.
Extreme care should be taken when operating near loose objects
such as gravel, rocks, wire and other debris. Foreign objects
should be removed from the site to prevent machine damage and/
or bodily injury or even death. Any object that cannot be removed
must be clearly marked and carefully avoided by the operator.
Stop snow blowing immediately if the auger or fan strikes a foreign
object. Repair all damage before resuming snow blowing.
Blow snow at the speed that you can safely operate and control the Tractor and Snow
Blower. Safe speed depends on terrain and snow conditions. Normal ground speed range
is from 0.5 to 1.5 mph. Use slow speeds when operating on or near steep slopes, ditches,
drop-offs, overhead obstructions, power lines, or when debris and foreign objects are to be
avoided.
Snow Blowers are capable under adverse conditions of throwing
objects for great distances (200 feet or more). Do not allow the
snow stream to fall on passersby. Ice, debris and heavy snow
thrown from the snow blower can cause serious injury or death.
(SSB-7)
STOP SNOW BLOWING IF PASSERSBY ARE WITHIN 200 FEET.
When blowing snow with two machines in the same area be sure that windows are closed.
(SSB-10)
There are obvious and hidden potential hazards in the operation of this Snow Blower.
REMEMBER! This machine is often operated in deep snow where vision is reduced. The
fan blades of this Snow Blower can throw objects for great distances Serious injury or even
death may occur unless care is taken to insure the safety of the operator, bystanders, or
passersby in the area. Do not operate this machine with anyone in the immediate area.
Stop Snow Blowing if anyone is within 200 feet of Snow Blower.
Do not operate Snow Blower if excessive vibration exists. Shut down PTO and the Tractor
engine. Inspect the Snow Blower to determine the source of the vibration.
missing or damaged replace them immediately. Do not operate the Snow Blower until the
blades have been replaced and the Blower operates smoothly. Operating the Snow Blower
with excessive vibration can result in component failure and broken objects to be thrown
outward at very high velocities. To reduce the possibility of property damage, serious injury,
or even death, never allow the Snow Blower to be operated with blades missing.
SBX-75/87 04/19
© 2019 Alamo Group Inc.
SAFETY
(SSB-4)
Safety Section 1-8
(SSB-1)
(SSB-2)
(SSB-11)
If blades are
(SSB-12)
Advertisement
Table of Contents
