Joystick Control Harness (Option) - Schulte SBX-75/87 Operator's Manual

4. Mount the Valve Block (127-034) to the blower
frame using four 3/8" x 1-1/2" bolts and four 3/8"
locking flange nuts.
5. Attach hydraulic hoses to all the fittings. Route
all Hydraulic Hoses along the top of the Main
Housing. Secure to Hose Clamps.
6. Attach the solenoid plugs on the electrical
switch harness to the solenoids.
7. Attach the Valve Block Shield B750-401. Mount
on bolt used to install Valve Block Bracket and
double nut.

JOYSTICK CONTROL HARNESS (OPTION)

1. Attach the Solenoid Plugs from the Electrical Harness (277-010) to the Solenoids on the Hydraulic Block.
2. Route the harness up along the main hydraulic hoses and secure with zip ties.
3. Connect the brand specific harness adapter to the 6-pin connector and continue to secure it to the hoses.
NOTE: If using a LOW FLOW implement on a CAT skid steer, disconnect the bullet connector to disengage the
High-Flow signal on the short CAT specific harness 276-332. To access the connector, carefully cut away
shrink wrapping.
SBX-75/87 04/19
© 2019 Alamo Group Inc.
ASSEMBLY
Assembly Section 3-5