Skid Steer Electric Harness Kit; Bx Blower Electric Harness Kit - Schulte SBX-75/87 Operator's Manual

Skid Steer Electric Harness Kit

Refer to the Electrical Components Hydraulic Block
section of the Parts Manual
1. Attach the positive battery lead of the Skid
Steer Electrical Harness (277-008) to the
positive battery lead on the skid steer.
2. Attach the ground lead of the Skid Steer
Electrical Harness to the skid steer frame.
3. There are now two separate lines of the
harness. One line has switches on the end, the
other line has a 6-pin weather sealed plug end.
The line with the switches should be routed
from the battery of the skid steer underneath
the cab towards the front.
4. Drill a hole in the cab to allow the switches to be routed up into the cab.
5. Mount the switches inside the cab, using either the Switch Mount Bracket (B620-161) or the Switch Box
(276-321).
6. Route the 6-pin plug end up through the tube of the loader arm to the front of the skid steer. The 6-pin plug
can be secured in the most convenient location, such as with the hydraulic connections.

BX Blower Electric Harness Kit

Refer to the Electrical Components Hydraulic Block section of the Parts Manual
1. Attach the female solenoid plugs on the SBX Blower Electrical Harness (277-010) to the corresponding
solenoids on the Valve Block (127-034).
2. Route the 6-pin plug end of the harness up through the cut-out in the shield. Connect the plug end to the
plug end on the skid steer.
3. Secure harness to SBX Blower frame with cable ties.
SBX-75/87 04/19
© 2019 Alamo Group Inc.
ASSEMBLY
Assembly Section 3-6