Connecting The Snow Blower To The Tractor; Connecting The Snow Blower A-Frame To The Tractor - Schulte SBX-75/87 Operator's Manual

Snow removal

Table of Contents

Never run the Power Unit engine in a closed building or without adequate ventilation. The

exhaust fumes can be hazardous to your health.

Start the Power Unit only when properly seated in the Power Unit seat. Starting

a Power Unit in gear can result in injury or death. Read the Power Unit

Operator's Manual for proper starting instructions.

9. CONNECTING THE SNOW BLOWER TO THE TRACTOR

Use extreme caution when connecting the snow blower to the tractor. The snow blower should be securely

resting at ground level with the parking jack foot. Keep hands and feet out from under the snowblower and

clear of pinch points between the tractor and snow blower.

Always shut the Tractor completely down, place the transmission in park, and set the

parking brake before you or anyone else attempts to connect or disconnect the Implement

and Tractor hitches.

1. Make sure the tractor is equipped with the

correct PTO shaft. Change shafts if needed.

2. Shorten or remove the tractor drawbar to avoid

interference when raising and lowering the

implement.

3. Board the tractor and start the engine. Position

the tractor to the snow blower with the 3-point

lift arms positioned to attach to the snow blower

lower link pins.

Note: Set the 3-point lift control to "Position

Control" so that the lift arms maintain a constant

height when attaching the snow blower. See the

tractor Operator's Manual for correct settings when

attaching 3-point equipment.

SBX-75/87 04/19

OPERATION

(S3PT-15)

Operation Section 4-14

(SPU-23)

(SPU-19)

Table of Contents