Introduction - Mircom TX3 Series Installation And Operation Manual

This manual provides information about the installation and operation of the
Telephone Access System, and must be read in its entirety before beginning any
installation work.
Installation must be performed by a qualified technician and must adhere to the
standards and special notices set by the local regulatory bodies.
For warranty and special notices information see the Warranty chapter on page
104 and Special Notices on page 109.
Note: Mircom periodically updates panel firmware and Configurator
Software to add features and correct any minor inconsistencies. For
information about the latest firmware or software visit the Mircom
website at www.mircom.com.
Warning: The lobby control unit must be grounded by a
qualified electrician. An improperly grounded
unit can result in equipment malfunction and
electrical shock.
If you mount the lobby control unit outdoors,
follow these precautions:
Do not install the lobby unit in direct sunlight.
Use the rain hood and do not expose the lobby
unit to the elements. Make sure the lobby unit
is covered by a minimum 2 m (6 feet) overhang
in all directions.
Seal the openings in the lobby unit with
outdoor-rated weatherproof silicone.
Do not power wash the lobby unit.
Review our warranty and terms and
conditions, available at these links:
https://www.mircom.com/product-warranty
https://www.mircom.com/purchase-terms-and-conditions
https://www.mircom.com/software-license-terms-and-conditions
This manual explains
• Lobby Control Unit Installation and Operation
• NSL Control Unit Installation and Operation
• Card Reader Unit Integration
TX3 Telephone Access System Installation and Operation Manual
1

Introduction

7