Advertisement
4.2 Mount Back Box and Route Cables
To maintain structural integrity, before drilling into the mounting surface, make
sure it is at least 50mm (2") thick.
a. Using the mounting template, drill six holes on the wall or mounting surface:
Diameter
3/8" (9.5mm), depth 1/1/2" (40mm). To ensure proper installation,
make sure the drilled holes are of correct size.
b. Hammer the six screw anchors into the drilled holes.
c. Cables can enter the back box from the rear or from the side. If the cables are
going to enter from the rear, use the mounting template to drill a bottom conduit
hole for the cables.
d. Route the power and network cabling into the
back box.
·
If you are connecting the camera using a single
Ethernet cable with an RJ45 plug attached,
attach the RJ45 insertion tool included with the
camera to the RJ45 plug. Then, route the tool,
plug, and cable through the single cable rubber
seal included with the camera.
·
If you are connecting the camera in any other
way, route the cables through the multiple cable
rubber seal included with the camera.
Securely fasten the rubber seal to either the
bottom or the side conduit hole. In addition, FLIR
recommends applying 3M waterproofing tape on
the cables that pass through either conduit hole.
e. Mount the back box onto the wall or
surface. Using the Philips head
screwdriver, fasten the six TP4
tapping screws into the six screw
anchors.
Connect the Camera
Inside the back box, connect the
camera's system cable to the other
cables according to the information in
Connect the
Camera.
4.3 Mount and Aim the Camera
a. Attach the camera to the back box. With the
camera attached to the adapter plate, align the
triangle on the adapter plate with the triangle on
the back box.
Then, while carefully holding and fully supporting
the camera, to make sure the screws are not
bearing the camera's weight when tightening
them, use the Torx wrench to tighten the three
T20 screws attached to the adapter plate.
CB-6404/CB-6408 QIG Rev 100
This document does not contain any export-controlled information.
3.2
RJ45 Insertion
Tool
Single Cable
Rubber Seal
Mount Back Box
February 2021
Advertisement
