Advertisement
Change video format
Configure more than one camera at the same time
For information about using the camera's web page to configure the camera, see
the camera's installation and user guide. For information about using a supported
VMS to configure the camera, see the VMS documentation.
By default, DHCP is enabled on the camera and a DHCP server on the network
assigns the camera an IP address. For example, if the camera is managed by
FLIR's Horizon or Meridian VMS and the VMS is configured as a DHCP server, the
VMS automatically assigns the camera an IP address.
If the camera is managed by FLIR's Latitude VMS or is on a network with static IP
addressing, you can manually specify the camera's IP address using the DNA tool
or the camera's web page. The camera's default IP address is 192.168.0.250.
To manually specify the camera's IP address using the DNA tool:
a. Make sure the camera and the PC are on the same LAN segment.
b. Run the DNA tool (DNA.exe) by double-clicking
The Discover List
appears, showing
compatible
devices on the
LAN segment and
their current IP
addresses.
In the DNA Discover List, verify that the camera's status is Online.
If this is the first time you are configuring the camera or if it is the first time after
resetting the camera to its factory defaults, DNA automatically authenticates
the camera with the default password for the camera's admin user (admin).
If the admin user password has been changed, you need to authenticate the
camera.
In the DNA Discover List, right-click the camera and select Login.
In the DNA - Login window, type the password for the admin user. If you do
not know the admin user password, contact the person who configured the
camera's users and passwords.
Click Login, wait for
CB-6404/CB-6408 QIG Rev 100
Task
Ok status to appear, and then click Close.
This document does not contain any export-controlled information.
DNA tool
Camera's web page
•
•
.
•
February 2021
Advertisement
