Maintenance; General Instructions; Service Schedules - ProActiv HUSK-E Usage Instructions

HUSK-E usage instructions
After cleaning, check to make sure that the
plug connectors are not damp and, if required,
allow them to dry before re-starting the
product.
In addition, the plug connectors should be
lubricated with petroleum jelly after cleaning to
protect them against corrosion and moisture.
The product must not be cleaned using
steam or high pressure.
Recommended care:
If you need care products for your product,
please contact PRO ACTIV. You can also
request our care set via the enclosed order
card or by telephone.

25 Maintenance

25.1 General instructions

The product is not a maintenance-free device.
Therefore, please observe the following
instructions about maintenance.
If repairs are required or there are any
defects in your product, in the interests of your
own safety, you should contact your
rehabilitation specialist dealer or PRO ACTIV
before using it again and have the defect
remedied. Screws and other elements need to
be secured properly again after repairs.
For tyres with tread: As soon as there is
one or more points with less than 1 mm of
tread on the product or the adapted
wheelchair, the tyres must be changed since
otherwise there is an increased risk of an
accident.
For tyres without thread: As soon as there
is one or more points where the tyre carcass or
the accident protection is visible on the product
or the adapted wheelchair, the tyres must be
changed since otherwise there is an increased
risk of an accident.
When maintaining the brakes, the
switching components, and the gear
components, it is imperative that the usage
instructions of the manufacturer which were
included in delivery are followed.
Only manufacturer's original parts may be
used when ordering spare parts.
Repairs and conversions to the product
may only be carried out by your rehabilitation
specialist dealer or PRO ACTIV.
Tightening torques and securing details for
fastening elements as shown in the table in
chapter 30 must be observed.

25.2 Service schedules

There is some maintenance work or checks
which should be carried out by the user
themselves at regular intervals (approximately
every 4 weeks depending on the frequency of
use):

The chain should be cleaned and
lubricated with chain oil (observe the
manufacturer's instructions).

Check the tyres for damage, foreign
bodies and any cracks that form.

Check the cable housings are seated
correctly and tightly in the gear cable
holders.

Cables and lines should be checked for
kinks and crushing.

Check the brake pads.

Check the tyre pressure and correct if
needed (the tyre pressure should always
be as printed on the tyre covers).
If you should discover any problems
during these checks, please immediately
contact your rehabilitation specialist dealer or
PRO ACTIV. Service and repair work on the
product may only be carried out by your
rehabilitation specialist dealer or PRO ACTIV.
In addition to these maintenance tasks by the
user, PRO ACTIV has prescribed
maintenance tasks to be carried out by the
rehabilitation specialist dealer or
26