Maintenance; General Instructions; Service Schedules - ProActiv SPEEDY F1 Operating Instructions Service Booklet

Clean your product with water, solvent or
neutral cleaning agents. Do not use any
abrasive cleaning agents or aggressive, acidic
cleaners, to prevent scratching or fading of the
coating or the anodised parts. Only use water
and soap to clean the seat and back padding.
The product must not be cleaned using
steam or high pressure.

29 Maintenance

29.1 General instructions

The product is not a maintenance-free device.
Therefore, please observe the following
instructions about maintenance.
If repairs are required or there are any
defects in your product, in the interests of your
own safety, you should contact your
rehabilitation specialist retailer or PRO ACTIV
before using it again and have the defect
remedied. Screws and other elements need to
be secured properly again after repairs.
For tyres with tread: As soon as there is
one or more points with less than 1 mm of
tread on the tyres, the tyres must be changed
as otherwise there is an increased risk of an
accident.
For tyres without thread: As soon as there
is one or more points where the tyre carcass or
the puncture-proofing is visible, the tyres must
be changed as otherwise there is an increased
risk of an accident.
Only manufacturer's original parts may be
used when ordering spare parts.
Repairs and conversions to the product
may only be carried out by your rehabilitation
specialist dealer or PRO ACTIV.
Tightening torques and securing details for
fastening elements as shown in the table in
chapter 34 must be observed.
33
Operating instructions SPEEDY F1

29.2 Service schedules

There is some maintenance work or checks
which should be carried out by the user
themselves at regular intervals (approximately
every 4 weeks depending on the frequency of
use):

Check the tyres for damage, foreign bodies
and any cracks that form.

Check the tyre pressure and correct if
needed (the tyre pressure should always
be as printed on the tyre covers).

Check the function of the anti-tipping
device.

Check the stable stand of the seat and
back padding.

Check the tight fit of the fixing screws on
the seat and back system.

Check the function and ease of running of
the quick release axles of the drive wheels
and anti-tipping support forks.
If you should discover any problems
during these checks, please immediately
contact your rehabilitation specialist dealer or
PRO ACTIV. Service and repair work on the
product may only be carried out by your
rehabilitation specialist dealer or PRO ACTIV.
In addition to these maintenance tasks/checks
by the user, PRO ACTIV has prescribed
maintenance tasks to be carried out by the
rehabilitation specialist dealer or
PRO ACTIV for safe operation of the product
and to minimise the risk to the user or third-
parties.
The initial inspection is performed six weeks
after delivery. The maintenance schedule can
be found in the inspection lists in chapter 37.
Subsequent inspections are then always
performed a year after the last inspection. The
maintenance schedule can be found in the
inspection lists in chapter 37.