Pedal Bearing Position - ProActiv HUSK-E Usage Instructions

HUSK-E usage instructions
and two positions can be used as travel
positions.
Figure 12: Positions of the bottom bracket support
In order to fold down the bottom bracket
support, the eccentric lever must be opened on
the left and right at the fork so that they stop
tensioning. Then turn the locking bolt 180° to
turn in the locking pin. A locking notch keeps
the pin in this position. Now the bottom bracket
support can be folded down. To latch the pin
into a locking position again, the pin must be
turned out of the locking notch.
As soon as the bottom bracket support is
in one of both driving positions and you wish to
drive the product, the eccentric lever must be
tensioned.
Eccentric lever
Figure 13: Eccentric lever and locking bolt for
folding down the bottom bracket support

20.2.3 Pedal bearing position

Using the adjustable bottom bracket
support, the angle and length of the bottom
bracket position can be adjusted.
The angle is adjusted via the locking position
of the locking bolt on the right fork tube and/or
gearing directly below the bottom bracket.
1. Adjusting the angle via the locking
Figure 14: Bottom bracket positions
Locking
bolt
Figure 15: Standard position of the insert
position of the locking bolt: The locking
bolt on the fork tube can always lock into
two positions for the travel position. Please
consult chapter "20.2.2 Folding down the
bottom bracket support" for the adjustment
process. If neither of the two positions is
optimal, there is the option of turning the
screwed-in insert, which produces two
additional positions for the bottom bracket
support. To do this, remove the M5
countersunk screw (AF 3 mm) used to
fasten the insert. Remove the insert and
reinsert it turned by 180° so that what used
to be the front side of the insert is now
pointing towards the rear. Afterwards,
tighten up the M5 countersunk screw at
4 Nm and secure it with thread lock fluid.
M6 Tensioning screw
for chain tension
M5 Countersunk screw for
clamping the insert
16