Table of Contents
Advertisement
HUSK-E usage instructions
20 Functional elements
20.1 Parking stand
20.1.1 Active and passive positions
By pressing down and turning the operating
lever outwards or inwards, the parking stand
position can be changed from the active to the
passive position and vice versa. The passive
position can also be called the travel position.
The parking stand is then folded in to save
space.
Figure 6: Press down and turn the operating lever
Figure 7: Parking stand in the active position
Figure 8: Parking stand in the passive position
20.1.2 Parking stand height adjustment
for and may only be carried out by a
rehabilitation specialist dealer or PRO ACTIV
The height adjustment of the parking stand is
important in order to bring the docking plate of
the product to the correct (height) position
relative to the adapter.
For setting the height of the parking stand, the
following must be observed: The distance from
the floor to the lower edge of the front of the
towing attachment (on the wheelchair side)
should be the same as the distance from the
Operating
ground to the upper edge of the attachment
lever
bolt (on the product side). If this distances are
different due to the hole pattern, the distance
from the ground to the upper edge of the
attachment bolt may be up to max. 1 cm
longer. In this case, the product can be hooked
onto the adapter by tipping slightly backwards
(over the parking stand).
Figure 9: Measurement from the ground to the lower
edge of the front of the towing attachment
The following instructions are intended
Front of
the towing
attachment
Distance
from the
ground to
the lower
edge of the
front
14
Advertisement
Table of Contents
