Drive Wheel And Tyre Pressure - ProActiv HUSK-E Usage Instructions

HUSK-E usage instructions

19 Drive wheel and tyre pressure

Check the tyre inflation pressure at
regular intervals as well as after extreme
temperature effects. The recommended tyre
pressure is printed on the side of the tyre.
This should be observed.
If the pressure is too high, the tyre may
burst. For this reason, product tyres may not
be exposed to unusually high temperatures
such as under glass in the summer.
When inflating the tyres, make sure that
the prescribed air pressure is not exceeded.
To check or correct the tyre pressure,
proceed as follows:
1. Secure the product to prevent it rolling
away.
2. The drive wheel is normally fitted with a car
tyre valve. Unscrew the valve cap.
Valve with cap
Figure 3: Valve with cap
Place the valve attachment of the
3.
compressed air device or the compressor
onto the valve and secure the connection
by applying the lever.
4. Now check the tyre pressure. If the tyre
pressure does not match the
specifications, correct it.
5. Afterwards, release the clamp lever, pull
the valve attachment off the valve and
replace the valve cap.
Figure 4: Compressor
Clamp lever
Figure 5: Valve adapter and clamp lever of the
compressor
Instructions for inserting a new hose:

Before inserting a new hose, the rim and
the inner tyre side wall must be checked
for foreign objects and cleaned if
necessary.

The condition of the rim tape must be
checked, especially at the valve hole.

Before inflating, the entire tyre should be
checked on both sides, to ensure that the
hose is not pinched between the tyre bead
and the rim.

Carefully pull out the valve such that the
hose fits into the optimal position around
the valve.
Valve
adapter
13