Introduction - ProActiv HUSK-E Usage Instructions

HUSK-E usage instructions
The product is tested to ensure it is completely
functional before shipping and packed in
special boxes. However, please check the
product immediately upon receipt, preferably in
the presence of the freight company, for any
damage which may have occurred in transit. If
you are of the opinion that damage has
occurred during transit, please do the
following:
1. Record a statement of facts in the
presence of the freight company - photo
documentation of the packaged product
and the unpacked product with detailed
images of product damage
2. Preparation of a declaration of assignment
- you assign all claims from this damage to
the freight company.
3. Statement of facts/photo documentation,
delivery note, and declaration of
assignment are sent to PRO ACTIV.
Failing to observe these instructions, or
reporting damage after acceptance, means
that the damage cannot be acknowledged.
PRO ACTIV will subsequently review the
damage and discuss additional steps with you
(shipment of replacement parts, returning the
product to PRO ACTIV for a complete repair,
etc.).
5

Introduction

Before starting your first trip, familiarise
yourself with these usage instructions and the
usage instructions for the coupled wheelchair,
paying particular attention to all the safety
information and hazard warnings they contain.
Allow your therapists and doctors to advise
you, your carers, and assistants on how to use
the product and what you are safe to do with
the product based on your current ability.
Under no circumstances should you do
anything with or in the product which you have
not learnt to do and have not mastered.
You, your carers, and assistants should also
seek advice from your therapists and doctors
as well as the rehabilitation specialist dealer
about the use and settings of your product as
well as all the safety accessories available
(e.g. chest belt and waist-belt).
It is then vital that the advice from
doctors, therapists and the rehabilitation
specialist dealer on the necessary safety
accessories should be followed.
If you are not sure how to handle the
product or if technical faults occur, please
contact your rehabilitation specialist dealer or
PRO ACTIV before using it.
When operating the product, the
wheelchair usage instructions must also be
observed. Information on limit values must not
be exceeded. If the values in the two sets of
usage instructions differ, the lower limit is the
one which applies.
The control software is programmed at
the factory to ensure that the legal
requirements are met. If changing the
software, it must be ensured that these
requirements are still met.
Never leave the product unattended,
either when it is switched on or switched off. If
this cannot be avoided, removing the
rechargeable battery/batteries and the display
can help prevent unauthorised use.
Secure the product from unauthorised
use and theft.
When combining your product with
equipment made by other manufacturers,
make sure that the individual components and
the unit made up of them still work
appropriately. You can get information on the
suitability of a combination from the
manufacturer of the third-party components or
from your rehabilitation specialist retailer.
The product contains small parts that may
pose a choking hazard for children.
5