Chain Container; Removing Chain Container (Figure 17); Installing Chain Container (Figure 17) - R&M LM Installation And Maintenance Manual

LM10 I&M MANUAL/EN/11.30.2010
7.7

Chain Container

Figure 17. Chain Container Installation
m
CAUTION: Chain container must be installed for effective operation of travel limit switch.

7.7.1 Removing Chain Container (Figure 17)

1. Remove cotter pin (item 5) from end of pin (item 3).
2. Pull pin (item 3) out while supporting chain container (item 2).
3. Remove chain container (item 2).

7.7.2 Installing Chain Container (Figure 17)

1. Insert load chain into chain container (item 2). Position chain container (item 2) onto hoist mounting
bracket (item 1).
2. Align holes and insert pin (item 3) through container (item 2) and hoist mounting bracket (item 1).
3. Place washer (item 4) onto pin (item 3).
4. Insert and secure cotter pin (item 5).
R&M Materials Handling, Inc. | 4501 Gateway Boulevard, Springfield, Ohio 45502 | PH: 1-937-525-5100 | FAX: 1-937-325-5319
This document and the information contained herein, is the exclusive property of R&M Materials Handling, Inc., and represents a non-public, confidential and proprietary trade secret
that may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of R&M Materials Handling, Inc.
Copyright © (2010) R&M Materials Handling, Inc. All rights reserved.
34/85