Advertisement
User manual
5. Initial start and calibration of the speed
5.1)
To start operating the turntable at the desired speed, press the relevant labelled button on the
motor housing.
We recommend letting the turntable run-in for about 15-30 minutes when using it for the first time.
Reference Jubilee
Pic. 16: Control panel
5.2)
Thanks to the newly developed motor control, the
automatically in order to always maintain the perfect speed.
However, manual calibration is also possible. We recommend this if the turntable has not been in
use for a long time, if parts (e.g. the belt) have been replaced, or if the turntable is set up again
after moving.
If you would like to start the calibration manually, please proceed as follows to recalibrate all three
speeds. This process takes about 5 minutes.
Hold down the OFF button until the 33 button flashes and the platter begins to turn.
> The speed 33rpm is now calibrating.
When the 33 button lights up continuously and the 45 button starts to flash.
> The 33rpm speed is calibrated and the turntable is now calibrating 45rpm.
When the 45 button lights up continuously and the 78 button starts to flash.
> The 45rpm speed is calibrated and the turntable is now calibrating 78rpm.
The calibration for 78rpm is complete when all 3 speed options and the OFF button flash alternately.
A longer press on OFF (speed options stop flashing) saves the calibration of all three speeds.
To stop the calibration process you can press any button.
Page 14
Reference Jubilee
turntable calibrates itself
© clearaudio electronic GmbH, 2021-04
Advertisement
