Table of Contents
Advertisement
Connecting a personal computer
The System can be connected to a personal computer either directly or via a network
(LAN) in order to update software, change remote settings or perform diagnostic tests.
Connecting a PC to the System without LAN
To connect the System to a personal computer not connected to a LAN:
1.
Connect an Ethernet cable to the System connector and to the network interface card of your
PC.
2.
From the H
H
P
OME
AGE
C
ONFIGURATION
Ensure that the System belongs to the same subnet as the PC, but has a different address. If
this is not true, change the System's IP address and restart the system.
3.
Start the browser on your PC. In the address bar, enter the System's IP address. The web page
manager will appear.
Connecting to the System via a PC in a LAN
To connect to the System from a PC in a LAN:
1.
Ensure that a LAN cable connects the System's rear connector to your LAN. The PC can be
connected to a LAN node or to the LAN OUT connector at the rear of the System.
2.
Switch on the System.
3.
Navigate through the following menus:
H
P
OME
AGE
C
ONFIGURATION
4.
If your LAN does not use a DHCP server, leave the Automatic IP Address box unchecked and
enter the IP Address, the SubNet mask, Gateway IP Address and the DNS Server IP Address
supplied by the network administrator, then restart the System.
5.
On the PC, start Internet Explorer. Enter the System's IP address in the address bar of the
browser.
6.
The web page manager will appear.
92
P
, navigate through the following menus:
OME
AGE
/ S
/ I
ETTINGS
NSTALLATION
/ S
/ I
ETTINGS
NSTALLATION
/ N
I
ETWORK
NTERFACES
/ N
I
ETWORK
NTERFACES
/ I
/ I
C
P
P
ONFIGURATION
/ I
/ I
C
P
P
ONFIGURATION
/ I
P
/ I
P
Advertisement
Table of Contents
