Operation And Use; First Time Equipment Is Switched On; Licence Code Insertion - Aethra Vega X5 User Manual

Operation and use

This section of the manual explains the basic functionality of the System.
It is assumed that the system is correctly installed.

First time equipment is switched on

!
ATTENTION !!! You have to insert SW licence enabling code (AETHRA
SOFTWARE LICENCE KEY)
First time the system is switched on, you need to:
1. insert the licence code;
2. Set some Location parameters .

Licence code insertion

When the equipment is switched on for
the first time, the
appear on the screen, and you can insert
the licence code.
Now several choices are available:
A) You can insert the licence code and enable it by pressing the
B) You can going on using the system in TEMPORARY version by pressing the
L page will appear to set several important parameters (see "Localization" §) and you'll
OCALIZATION
have 12 hours working time (switched on system time); once ended, system will stop waiting for the
licence code.
In the status bar, below time indication,
remaining working time is shown.
C) insert a DEMO licence code and enable it by pressing the
In the status bar, below time indication,
remaining working time is shown.
Note: to insert licence code after B) and C) choices, see the "Licences" §.
L
page will
ICENCES
button.
Enable licence
Start
button.
Enable licence
button;
21