Connecting A Personal Computer; Connecting Apc To The System Without Lan; Connecting To The System Via Apc In Alan - Aethra Vega X3 Use And Installation Manual

Connecting a personal computer

The System can be connected to a personal computer either directly or via a network (LAN) in order to
update software, change remote settings or perform diagnostic tests.
Connecting a PC to the System without LAN
To connect the System to a personal computer not connected to a LAN:
1. Connect an Ethernet cable to the System connector and to the network interface card of your
PC.
2. From the home page, navigate through the following menus:
Ensure that the System belongs to the same subnet as the PC, but has a different address. If
this is not true, change the System's IP address and restart the system.
3. Start the browser on your PC. In the address bar, enter the System's IP address. The web page
manager will appear.
Connecting to the System via a PC in a LAN
To connect to the System from a PC in a LAN:
1. Ensure that a LAN cable connects the System's rear connector to your LAN. The PC can be
connected to a LAN node or to the LAN OUT connector at the rear of the System.
2. Switch on the System.
3. Navigate through the following menus:
4. If your LAN does not use a DHCP server, leave the Automatic IP Address box unchecked and
enter the IP Address, the SubNet mask, Gateway IP Address and the DNS Server IP Address
supplied by the network administrator, then restart the System.
5. On the PC, start Internet Explorer. Enter the System's IP address in the address bar of the
browser.
6. The web page manager will appear.
1.) H P
OME AGE
2.) S
ETTINGS
3.) I
NSTALLATION
4.) N I
ETWORK NTERFACES
5.) I
P
6.) I C
P ONFIGURATION
7.) I C
P ONFIGURATION
1.) H P
OME AGE
2.) S
ETTINGS
3.) I
NSTALLATION
4.) N I
ETWORK NTERFACES
5.) IP
6.) IP C
ONFIGURATION
7.) IP C
ONFIGURATION
.
85