Table of Contents
Advertisement
NIC network interface (option)
This interface can be used by means of the "XLNA" external module
(see "X LINE NETWORK ADAPTER" §).
G.703 interface configuration (option whit license)
In order to use G.703, it is necessary to have a licence (see section on licensing for
more information).
In this menu you can:
Choose either the
If the system has already been configured to support a PRI interface (either
Euro or National), the E1/T1 option is not available and the system is
automatically set to the appropriate mode:
Choose the
Set the
Network
Enable/Disable
To make an automatic call:
1. Enter Audio-Video call page.
2. Select NIC in Type of call drop-down menu.
3. Wait for few seconds, and the System will automatically start the call.
Enable/Disable
Enable/Disable
Enable/Disable the
Configure the System to be either
G.703 advanced
Select Cable length, from the drop-down menu, you can select the length of
the G.703 cable.
Note:
If the system is configured with PRI lines, Euro or National, the System automatically
selects the net in the following way:
Primary Rate Euro Access → G.703 E1;
Primary Rate National Access → G.703 T1.
Note:
If "Automatic call" option is enabled, System will start the call as soon as it notices the
presence of a line.
72
or
protocol
E1
T1
Euro Primary Access
National Primary Access
.
Rate
speed (
or
64K
.
Automatic call
.
Use Ch16
(E1 only).
CRC4
Enabled Alarms
settings (T1 only).
G.703 E1;
G.703 T1.
).
56K
option.
or
in calls.
Master
Slave
Advertisement
Table of Contents
