Wall Mounting Installation; Front Panel Features - Extron electronics FPC 6000 Setup Manual

Wall Mounting Installation

1.
Download the cut-out template for the TLP Pro
1520MG from www.extron.com. Print it at 100%
(no scaling).
2.
Use the template to mark the wall, cut the hole, and
drill the four pilot holes (see figure 2,
The size of the cut-out hole is 8.90 inches (226 mm)
wide by 5.70 inches (145 mm) high.
3.
The FPC 6000 ships, already mounted, in a
rackmountable metal panel. Remove the FPC 6000,
and unscrew the mounting plate from the panel.
4.
Secure the mounting plate to the mounting
surface with four #10 screws (
fasteners that are appropriate for the mounting
surface.
5.
Run and connect cables to the back of the
touchpanel ( 3 , see
next page).
6.
I
nsert the two provided Phillips pan head #6-32 x
¾-inch screws with washers in the mounting screw
figure
slot ( 4 , see
a gap for the flange at the bottom of the mounting
plate to fit into ( 6 ).
7.
Hold the touchpanel at a slight angle and lower the
notches at the top of the back panel (
hooks of the mounting plate.
8.
Swing down the bottom of the touchpanel so it lies
flat against the mounting plate. The flange at the
bottom of the mounting plate sits in a groove in the
bottom of the touchpanel (
9.
Secure the touchpanel to the mounting plate with
the mounting screws (

Front Panel Features

E E E
Figure 3.
FPC 6000 Front Panel
1 ).
2 ). Use screws and
Rear Panel Features on the
4,
J on the next page). Leave
5 ) over the
).
6
7
).
A A A B B B C C C D D D
F F F G G G
2 2 2
Align the mounting plate with
the wall and mark for screws.
Secure the mounting plate
to the wall with 4 screws.
6 6 6
The flange at the bottom of the
mounting plate sits in a groove
in the bottom of the
touchpanel.
Back View
Figure 2.
Wall Mounting the FPC 6000
Communication LED
A
powered on.
Status Light —
B
Ambient Light Sensor —
C
and adjusts screen brightness.
D Capacitive Touch Screen —
1366x768 resolution.
E Speakers —
presses.
Motion Sensor —
F
touchpanel.
Menu Button —
G
calibration screen (see
is accessed from under the touchpanel. It performs the
same function as the rear panel
easier to reach when the touchpanel is installed
NOTE: Extron recommends using the Settings link
E E E
on the Login Screen
on-screen menus.
1
1 1 1
5 5 5
Hold the touchpanel at
3 3 3
a slight angle. Mount
the touchpanel over
the two hooks on the
mounting plate.
4 4 4
Place the 2 provided mounting screws
with washers in the mounting screw slot
in the touchpanel.
7 7 7
Secure the touchpanel by tightening the
mounting screws against the base of the
mounting plate.
— Lights briefly when unit is
Lights briefly when unit is powered on.
Monitors ambient light level
A 15.6 inch screen with
Provide audible feedback from button
Detects motion in front of the
Activates the setup menu and
Setup Menu on page 4). It
Menu
button but is
(see page 5) to open the
FPC 6000
.
3