Sam4s ER180T Quick Setup Manual
Hide thumbs
Also See for ER180T:
- Operation and programming manual (92 pages) ,
- Operator's and programming manual (89 pages) ,
- Service manual (65 pages)
Advertisement
SAM4s ER180T Quick Setup Guide – www.hotpos.com.au Copyright 2013
1. IMPORTANT - Before you Begin
a.
The Cash Register is already setup for 10% GST on ALL departments. You can change this later on if you need a
Department that is GST FREE. Instructions are in the main user guide.
b.
Please unpack all items and DO NOT power up the Register.
c.
You do not need to complete any steps after Step 3. You only need Step 4 and beyond if you want to customise your
Receipts, Departments etc.
d.
Follow each step below slowly and carefully to avoid making any mistakes.
2. Insert Paper
a.
Remove the Tape that is holding the Printer Cover in place.
b.
Using your Finger, lift the Cover upwards gently. It will pivot and pop open.
c.
Now remove the Tape holding the Release Bar in place.
Advertisement
Table of Contents
Related Manuals for Sam4s ER180T
Summary of Contents for Sam4s ER180T
- Page 1 SAM4s ER180T Quick Setup Guide – www.hotpos.com.au Copyright 2013 1. IMPORTANT - Before you Begin The Cash Register is already setup for 10% GST on ALL departments. You can change this later on if you need a Department that is GST FREE. Instructions are in the main user guide.
- Page 2 SAM4s ER180T Quick Setup Guide – www.hotpos.com.au Copyright 2013 Now, lift the Printer Release bar. It is fixed at the other end and will pivot open. Remove and dispose of the Small Piece of Receipt Paper Prepare a Roll of Thermal Paper and simply drop it in the paper holder in the position shown.
- Page 3 SAM4s ER180T Quick Setup Guide – www.hotpos.com.au Copyright 2013 Now feed the paper through the Printer Cover as shown. Now replace the printer cover ensuring you locate the plastic tabs then snapping shut. 3. Cash Register FULL Reset Ensure the Power is On at the wall but the Small Power Plug is NOT inserted into Register.
- Page 4 SAM4s ER180T Quick Setup Guide – www.hotpos.com.au Copyright 2013 Turn the lock to “S” Position - it’s a hidden position after PGM position. Now, press and HOLD the “Charge” Button whilst inserting the Small power plug into the Register. You will hear a short beep. With 0.00 on the display.
- Page 5 SAM4s ER180T Quick Setup Guide – www.hotpos.com.au Copyright 2013 4. Receipt Header Programming (Add Shop Name, TAX Invoice, Phone Number etc) Register should be ON. Insert the C key into the lock Turn the lock to “PGM” Position. To change Line 1 of the Receipt Enter the numbers 3 0 0 0 1 then press [SUB-TOTAL] Button You are now programming Line 1 of your Receipt.
- Page 6 SAM4s ER180T Quick Setup Guide – www.hotpos.com.au Copyright 2013 5. Department Name Programming (Change the Name of Departments: Food, Drinks, Coffee etc) Register should be ON. Insert the C key into the lock Turn the lock to “PGM” Position. To Rename Department 1 of the Register...
Need help?
Do you have a question about the ER180T and is the answer not in the manual?
Questions and answers