Start Up The Inverter - SAJ AS1-3KS-5.1 User Manual

LED lamps state
Green/R
A ed LED
lamp
Residual battery capacity
B
percentage (SOC)

5.2 Start Up the Inverter

If only AS1 is installed, the system shall be turned ON in the correct
sequence as follows:
1) Turn ON the DC switch at the right side of the AS1;
2) Turn on the battery switch at the right side of the AS1 until it lights
in blue.
3) Wait for 30s and observe the LED indicators and LCD on the front
of AS1 to check the running status of the system. (Please refer to
Table 5.1)
If there is any B1 connected to the AS1, the system shall be
turned ON in the correct sequence as follows:
Green lamp flicker
from bottom to top
Green lamp flicker
from top to bottom
Red lamp flicker:1
s/time
Green lamp and red
lamp flicker in
alternative
Red lamp Always light
on
Table 5.1 Human-computer interface description
Battery discharging
Battery charging
Standby
Procedures are being upgrade
Faults in device
Total remained battery capacity of the system
- 60 -
Description