Advertisement
PD 29160N Mac.book Page 15 Monday, November 13, 2000 1:38 PM
Plug the remaining connector(s) into the internal LVD SCSI
S
3
TEP
devices.
N
OTE
the same for the 29160N.
N
OTE
termination disabled and cannot be changed. Proper SCSI
bus termination is provided by the terminator at the end of
the LVD SCSI cable.
After you have connected all your inter-
S
4
TEP
nal LVD SCSI devices to the Adaptec
PowerDomain 29160 or 29160N, plug a
power cord bundle from the computer
into each device.
If you want to install internal Fast/Ultra-SE SCSI devices, go to
S
5
TEP
the next section, Connecting Internal 50-Pin Fast/Ultra-SE SCSI
Devices on page 17.
If you want to install internal Ultra/Wide SCSI devices on the
29160, go to the section Connecting Internal 68-Pin SE SCSI
Devices (29160 only) on page 20.
Adaptec PowerDomain 29160/29160N
The illustration shows the 29160 card. The procedure is
LVD Ultra160
SCSI devices
Plug first device
Built-in terminator
to this connector
on cable
Internal LVD SCSI devices come from the factory with
Power cord bundle
from the computer
15
Advertisement
