Adaptec DuraStor 6200SR User Manual page 13

5 Enter a name for the array.
You can enter up to 27 characters (A-Z and 0-9), one at a time.
↑ ↓
Use and
until the name is complete, then press Enter.
Note: If you do not want to name the array, skip this step by
pressing Enter. You can add or change the name later. The
array will be given the name A1 as a default to identify it.
The names will increment by one value for each new
unnamed array (A2, A3...).
The system asks if you want to create one partition now for the
entire array.
Note: If you want to create a multiple-partition array, see
Creating a Multiple-Partition Array on page
6 Choose Y to create a single-partition array, then press Enter.
7 Choose the LUN for the array, then press Enter. (Choose any
number from 0-63.)
The system warns you about the LUN for Unix and Macintosh
OSs. (See the Note on
Enter and the system asks if you want to be warned again. Select
No to avoid receiving this warning again, otherwise select Yes to
be warned the next time you create a partition.
8 Choose the RAID level, then press Enter. (You can choose from
RAID 0, RAID 3, RAID 4, RAID 5, RAID 50, VOLUME, or
MIRRORED.)
Note: A RAID 10 array is automatically created when there
are more than two disk drives in a mirrored array.
If you selected RAID 50 as the array type, the Pick RAID 50
I
Array Size screen appears.
Choose the configuration you want, then press Enter.
If you chose any array type other than RAID 50, the Number
I
of Drives screen appears.
Creating and Managing Arrays and Partitions
to choose a character and then press Enter. Repeat
page 2-2 for detailed information.) Press
2-6.
2-3