Table of Contents
Advertisement
Gooseneck, Frame, and Deck
Repairing Structural Defects
If any structural defect is found, the fault must be
corrected before further use of the vehicle. To continue
usage could endanger the trailer, its load, personnel,
traffic, and properties. If any cracks or breaks are found,
contact the Landoll factory immediately and be prepared
to provide photos and descriptions of damaged areas.
Contacting Landoll is required for reporting purposes.
Inspect the deck daily for broken or missing planks or
missing attachments. Replace any defective parts
promptly.
Electrical System
1. Maintenance of the electrical system consists of
inspection and minor servicing. Any wire, connection
or electrical component showing signs of corrosion,
wear, breakage or unraveling must be repaired or
replaced.
TABLE OF CONTENTS
2. Frayed or unraveling wire must have the defective
section removed and replaced with wire of the same
color and gauge. Seal all connections and insulate.
Before cutting or altering any blue Grote wiring
harness, contact your Landoll dealer and inquire
about the wiring harness warranty.
3. Corroded terminals must have the corrosion
removed, source of corrosion neutralized and the
terminals resealed, protected, and insulated.
4. Fuse or circuit breaker burn-out or blow-out usually
indicates an electrical short-circuit, although a fuse
can occasionally fail from vibration. Insert a second
fuse or reset the breaker. If this fuse immediately
burns out or the breaker trips, locate the cause of the
electrical short and repair.
5. A light that repeatedly burns-out usually indicates a
loose connection, poor system ground, or a
malfunctioning voltage regulator. Locate the source
of the problem and repair. System grounds must be
grounded to bare metal surfaces. Paint, grease, wax,
and other coatings act as insulators. Replacement
lamps must be equivalent to the factory installed
lamp.
MAINTENANCE AND LUBRICATION
4-7
Advertisement
Table of Contents
