Table of Contents
Advertisement
5. Install the brake keeper onto the shoes. Install shoes
onto the spider by placing shoes in place on the
anchor pins, then "wrap" the two shoes into place
about the spider.
TABLE OF CONTENTS
Figure 4-11: Axle and Brake Assembly
6. Install the shoe retractor spring onto the shoes.
7. Connect slack adjuster to brake chamber pushrod.
8. Adjust automatic slack adjuster as outlined in
MAINTENANCE AND LUBRICATION
TYPE I
RH
VIEWED FROM HEAD END
NOTE: RH DOES NOT NECESSARILY
CORRESPOND W/ RIGHT SIDE OF TRAILER
"Adjusting Slack Adjuster" on page
TYPE II
LH
4-19.
4-17
Advertisement
Table of Contents
