A Configuring Aro-1130U2 With The Scsi Select Utility - Adaptec ARO-1130U2 Installation And Hardware Manual

Configuring ARO-1130U2
with the SCSISelect Utility
The SCSISelect configuration utility allows you to change SCSI set-
tings without opening the server chassis or handling the card.
SCSISelect also contains utilities that allow you to low-level format
or verify the disk media of your SCSI hard disk drives.
The SCSISelect settings are listed in the table below. If you want to
view and/or change the current settings, or if you would like to for-
mat or verify a disk, see Starting the SCSISelect Utility on page A-2.
Detailed descriptions of each setting begin on page A-4.
SCSI Bus Interface Definitions
Host Adapter SCSI ID
SCSI Parity Checking
Host Adapter SCSI Termination
Host Adapter Ultra SCSI
SCSI Device Configuration
Initiate Sync Negotiation
Maximum Transfer Rate
Enable Disconnection
Initiate Wide Negotiation
Send Start Unit Command
Include in BIOS Scan
Additional Options
Array1000U2 BIOS
BIOS Support for Bootable CD-ROM
1
This option is available only if Wide SCSI is sup-
ported on the motherboard.
A
1
A-1