Adaptec ARO-1130U2 Installation And Hardware Manual page 46

ARO-1130U2 Installation and Hardware Guide
NetWare 5.0
Follow these instructions only if you are installing NetWare 5.0 for
the first time:
1
Install DOS on your system and create a DOS partition.
2
Copy the aspi8u2.sys and aspicd.sys files from the \dos direc-
tory on the Adaptec Array1000U2 Family Manager Set driver
diskette to a directory (e.g., c:\scsi ) on your hard disk drive.
3
When using a SCSI CD-ROM, edit the config.sys file to include
command lines for aspi8dos.sys and aspicd.sys . The following
sample command lines for the config.sys file are appropriate for
most systems:
device=c:\scsi\aspi8u2.sys /d
device=c:\scsi\aspicd.sys /d:aspicd0
Note:
For non-Ultra2 systems, use aspi8dos.sys
instead of aspi8u2.sys in the command line (for exam-
ple, device=c:\scsi\aspi8dos.sys /d).
4
Edit the autoexec.bat file to include a command line for
mscdex.exe (the mscdex . exe file is included with MS-DOS 6.x
and above) . The following sample command lines for the
autoexec.bat file are appropriate for most systems:
c:\dos\mscdex.exe /d:aspicd0 /M:12
(This assigns the CD-ROM the next available drive letter, typi-
cally D if there is only one DOS drive.)
5
Reboot the system to the DOS partition.
6
Insert the NetWare 5.0 CD in your CD-ROM drive.
7
Go to the CD-ROM drive.
8
Type Install and press Enter.
9
Follow the procedures in your NetWare documentation for
installing a new server.
6-6