Installing The Driver When Installing Windows Nt - Adaptec ARO-1130U2 Installation And Hardware Manual

Installing the Driver When Installing Windows NT

To install the cda1000.sys driver when you are installing Windows
NT, follow these steps:
Note:
During Windows NT installation, if your system
configuration has multiple arrays and/or single drives,
Windows NT limits the size of the partitions you can create
to 1 GByte. To work around this 1 GByte limitation, see
Windows NT 1 GByte Partition Limitation on page 5-5.
1
Start your system with the Windows NT Boot Diskette in the
floppy drive or the Windows NT Boot CD-ROM in the
CD-ROM drive.
Note:
When using a SCSI CD-ROM drive to install
Windows NT from the bootable CD-ROM, make sure
BIOS Support for Bootable CD-ROM is enabled in
SCSISelect.
2
Windows NT Boot Diskette installation: When prompted, insert
diskette #2 in your floppy drive. After a few moments you will
see a blue screen. To setup Windows NT now, press Enter and
continue with Step 3 below.
Windows NT Boot CD-ROM installation: When the following mes-
sage appears onscreen, press the F6 key and skip to Step 4 below.
Setup is inspecting your computer system's hardware...
3
Press S to skip autodetection of your SCSI host adapter.
4
Press S again to specify an additional device.
5
Press Enter to select Others; insert the Appropriate Adaptec
Array1000U2 Family Manager Set driver diskette (Disk A or
Disk B) in your floppy disk drive and press Enter. (See Run-
ning the Array1000 BIOS & Driver Selection Utility on page 3-2
to determine the appropriate driver diskette.)
6
The screen displays the adapter drivers supported on the
diskette. Select the Adaptec Array1000U2 Family Adapter
driver and press Enter.
Installing the Software Driver for Windows NT
5-3