Adaptec ARO-1130U2 Installation And Hardware Manual page 44

ARO-1130U2 Installation and Hardware Guide
9
Follow the procedures in your NetWare documentation for
installing a new server.
10
If prompted to load an SMP Module, select No. (The SMP
Module can be installed once NetWare is up and running.)
11
When a screen appears that asks you to select a disk driver,
press Enter.
12
Press Insert to install an unlisted driver.
13
Insert the appropriate Adaptec Array1000U2 Family Manager
Set driver diskette (Disk A or Disk B) into your floppy disk
drive. (See Running the Array1000 BIOS & Driver Selection Util-
ity on page 3-2 to determine the appropriate driver diskette.)
14
Press F3 and specify the path to the cda1000h.ham driver. For
NetWare 4.1, the driver is located in \netware\v4_1x on the
diskette.
15
Select cda1000h.ham and press Enter.
16
When prompted to save existing file c:\nwserver\nbi.nlm , select
No.
17
When prompted to save existing file c:\nwserver\nwpaload.nlm ,
select No.
18
When prompted to save existing file c:\nwserver\nwpa.nlm ,
select No.
19
When prompted, select Select/Modify driver parameters.
20
Enter a valid slot number, then press Enter to Save field data.
21
Press F10 to Save parameter settings.
22
When prompted, select Save parameters and continue.
23
Select No when prompted to select an additional disk driver.
24
Select Continue Installation.
25
When NetWare installation is complete, install Adaptec CI/O
Management Software from the server console. Refer to the
Adaptec CI/O Management Software User's Guide for instructions
on installing and using the software.
6-4