Creating An Array With The Arrayconfigu2 Utility - Adaptec ARO-1130U2 Installation And Hardware Manual

Creating an Array With the
ArrayConfigU2 Utility
This chapter explains how to use the ArrayConfigU2 Utility to create
a bootable or non-bootable array on your system. If you want a boot-
able array on your system, you must use the ArrayConfigU2 utility
to create the bootable array.
Once the array is created, use Adaptec CI/O Management Software
to create additional arrays and to manage the arrays over the net-
work. Refer to the Adaptec CI/O Management Software User's Guide for
instructions on installing and using the software.
Note: ArrayConfigU2 runs from a self-booting diskette. If
you are changing the configuration of a system that is
already in use on a network, log all users off the system and
shut it down in an orderly manner before you start
ArrayConfigU2.
Caution:
It is strongly recommended that you consistently
and regularly backup your data to a backup media such as
tape so you may recover your data due to failure events not
protected by a fault tolerant array.
4
4-1