Table of Contents
Advertisement
ASA-7211C/F Installation Guide
Updating the Driver in Windows NT 4.0
This section describes the following procedures:
Removing the Old Driver
I
Adding the New Driver
I
Removing the Old Driver
To update the driver, you must first remove the driver. To remove
the driver:
1
Open the Windows Control Panel.
Double-click SCSI Adapters.
2
Click the Drivers tab.
3
4
Choose the appropriate driver from the list box.
5
Click the controller identified as an Adaptec Storage Accelerator 7211.
Click Remove and follow all Windows instructions. Windows
6
will prompt you to reboot the computer.
Adding the New Driver
To add the new driver:
1
Insert the disk containing the new driver.
2
Open the Windows Control Panel.
Double-click SCSI Adapters.
3
4
Click the Drivers tab.
Click Add, and then click Have Disk.
5
6
Click Browse and browse to the appropriate location on the
driver disk.
Click Open, and then click OK.
7
8
Click Adaptec Storage Accelerator 7211 (NT 4.0).
9
Click OK and follow all Windows instructions. Windows will
prompt you to reboot the computer.
A-4
Advertisement
Table of Contents
