Installing The Device Driver For Windows Nt; Installing The Driver - Adaptec 9110G User Reference

Adaptec Fibre Card 9110G User's Reference
Installing the Device Driver
for Windows NT 4.0
Before installing the Adaptec Fibre Card 9110G driver, Windows NT
4 should be installed.
Note: You cannot install the operating system to a drive
attached to the Adaptec Fibre Card 9110G.

Installing the Driver

To install the Windows NT driver, perform these steps:
1
Start Windows NT and log into an account with administrative
privileges.
2
Insert the Adaptec Fibre Channel Drivers disk into the floppy
drive.
3
From the Start button, select Settings.
4
From the Settings menu, select Control Panel.
5
From the Control Panel window, select SCSI Adapters icon.
6
From the SCSI Adapters window, select Drivers tab.
7
From the Drivers window, select Add.
8
Select Have Disk.
9
Click the Browse button.
10
Double-click the Winnt4 folder.
11
Click the Open button.
12
Click OK.
13
Select Adaptec AFC-9110G PCI 64-bit/66MHz Fibre Channel
1Gbit Controller.
14
Click OK.
12