Executing The Scsiselect Utility - Adaptec AHA-2940UW - Storage Controller UW SCSI 40 MBps User Manual

AHA-2940UW/OF and AHA-2944UW/OF User's Guide
4
5
6
Executing the SCSI Select Utility
At the ok prompt enter the following command:
The first screen is the SCSISelect Options screen which displays
options, one line at a time. Two options are available to you:
------------------[
Do you wish to configure the host adapter or run the SCSI disk
utilities?
{<Space> to select option
Select Option: [Configure/View Host Adapter Settings]
3-2
Downloaded from www.Manualslib.com
To verify the selection, type the following command at the ok
prompt:
pwd
To view the configuration properties of any selected single-
chip host adapter, type the following command at the ok
prompt:
.properties
To obtain firmware release and copyright information, type the
following at the ok prompt:
release
copyright
scsiselect
Configure/View Host Adapter Settings
SCSI Disk Utilities
To select an option, use the
the option, then press Enter. To exit SCSISelect, press Esc.
A screen similar to the one in Figure 3-1 appears:
AHA-294XU/UW/D
Copyright(c) 1996-1998 Adaptec, Inc. All rights reserved
Figure 3-1. SCSI Select Options Screen
manuals search engine
and keys or Spacebar to display
SCSISelect(R) Utility
SCSISelect Options
<Enter> to accept option
v1.06
]------------------
<Esc> to exit}