Other Initial Array Configuration Utility Options; Displaying Array Information - Adaptec AHA-3980 User Manual

AHA-3980/3980W/3985/3985W User's Guide
b
Check to make sure there is a load line for ardrvr . Your
startup.ncf should now load aha3980.dsk for every
installed AHA-398x adapter, followed by a single ardrvr
load line.
Note:
The aha3980.dsk driver supports the NetWare
tape backup utility, sbackup.nlm . Use aha3980.dsk ,
not the adaptec.nlm driver provided by NetWare,
when running this utility. Adaptec's aha3980.dsk
driver takes advantage of ASPI features bypassed by
adaptec.nlm .

Other Initial Array Configuration Utility Options

Creating an Array with the Initial Array Configuration Utility, which
begins on page 6-3, describes how to use the Initial Array Configura-
tion Utility to create an array that you can use for a boot device. Nor-
mally, this is the only task for which you will use this utility. Then
you can create and manage other arrays with the Administrator
Utility after you install NetWare.
This section describes the other Initial Array Configuration Utility
menu options, in case you need to use them.

Displaying Array Information

Follow these steps to display information about an array that has
already been defined on your system:
1
Select Display Arrays from the Main Menu.
2
When the Array Menu appears, move the highlight to the
array you want to view and press Enter.
6-14
AHA-3980/3980W/3985/3985W User's Guide
Stock Number: 510810-00, Rev. D
Print Spec Number: 493479-00
Current Date: 3/1/99
Page: 6-14
ECN Date: 3/19/96