The Scsiselect Configuration Utility; Default Configuration Settings - Adaptec AHA-3940 User Manual

3

The SCSISelect Configuration Utility

AHA-3940/3940W host adapters include an onboard SCSISelect con-
figuration utility that lets you change host adapter settings without
opening the computer or handling the host adapter. SCSISelect also
provides utilities for formatting SCSI disk devices and scanning
them for defects.

Default Configuration Settings

This table lists the settings you can change with SCSISelect and the
default value for each setting. Some settings apply to the channels;
other settings apply individually to each device on the bus.
Channel Settings
Host Adapter SCSI ID
SCSI Parity Checking
Host Adapter SCSI Termination
Reset SCSI Bus at IC Initialization
Channel BIOS
Support Removable Disks Under BIOS as Fixed Disks
Extended BIOS Translation for DOS Drives > 1 GByte
BIOS Support for More Than 2 Drives
Individual Settings for Each SCSI Device
Initiate Sync Negotiation
Maximum Sync Transfer Rate
Enable Disconnection
2
Send Start Unit Command
2
Include In BIOS Scan
4
Initiate Wide Negotiation
1
Both Channel A and Channel B.
2
Settings are valid only if channel BIOS is enabled.
3
20 MBytes/sec maximum synchronous transfer on AHA-3940W.
4
Applies to AHA-3940W only.
A AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA
A A
AHA-3940/3940W User's Guide
A
A A
Stock Number: 510600-00, Rev. A
A A
A A Print Spec Number: 492707-00
A A
Current Date: 8/24/94
AAAA AAAA A AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA
AAAA
Configuring Your Host Adapter
Default Value
7
Enabled
Enabled
Enabled
Enabled
2
Boot only
2
Enabled
2
Enabled
Default Value
Yes
10.0 MBytes/sec
Yes
No
Yes
Yes
Page: 3-3
ECN Date: 08/30/94
AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA
1
3
3-3
A
A A
A A
A A
A
A A
A A
AAAA A A A A