Installation; Connectors On The Host Adapter - Adaptec AHA-2740W User Manual

AHA-2740W/2742W/2744W User's Guide
EISA system from the diskette that came with your host
adapter to either the bootable ECU diskette or to the directory
on your hard disk where the utility is located.
3
Select the option in the ECU that allows you configure the
EISA slot in which the host adapter is installed.
4
Configure the host adapter parameters.

Installation

This section is intended primarily for users who are new to SCSI
peripherals, or have limited experience in installing an option board
in their computer system.
Note:
Experienced users may want to refer to Quick Installa-
tion on page 2-5.
The comprehensive instructions in this section guide you through
terminating the SCSI bus, setting the SCSI ID, installing the host
adapter, and connecting peripherals and cables.
Once the host adapter is properly installed in your EISA system, you
will have to configure it as explained in Chapter 3, Configuring the
Host Adapter.
To assist you with installation, Figure 2-1 shows the location of all the

connectors on the host adapter.

External LED
Floppy
Connector
Connector
Floppy
Enable
Jumper
Pin 1
Figure 2-1. Connectors on the Host Adapter
2-8
A AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA
A A
AHA-2740W/2742W/2744W User's Guide
A A
A A Stock Number: 510647-00, Rev. A
A
A A Print Spec Number: 492897-00
A A
Current Date: 8/3/94
AAAA AAAA A A AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA
AAAA
50-pin 8-bit
68-pin 16-bit
SCSI Internal
Wide SCSI
Connector
Internal Connector
Pin 1
ECN Date: 8/9/94
AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA
68-pin 16-bit
Wide SCSI
External
Connector
A
A A
A A
Page: 2-8 A A
A
A A
A A
AAAA AAAA AAAA AAAA AAAA A A A A